SPECIFICATION FOR APPROVAL
REF :
20070124-C
20080502-H
PROD.
NAME
PAGE: 7
ABC'S DWG NO.
ABC'S ITEM NO.
CM3225□□□□L□-□□□
WOUND CHIP INDUCTOR
Terminal
strength-pull test
Terminal shall not
be loosened or ruptured
A 0.5kg load shall be applied to both
Terminals in the axis direction for
1 minute﹒
After fluxing，Inductor shall be dipped in
a melted solder bath at 240±5
℃
for
5 seconds﹒
Solderability test
The terminal shall
be at least 90%
covered with solder
There shall be no
case deformation
change in
appearance or obliteration
of marking
Resistance to
solvent test
MIL-STD-202F，Method 215D
Climatic test
Temperature
characteristic
Humidity test
Cold test
1﹒Inductors shall be
no evidence of
electrical and mechanical
damage
2﹒Inductance shall
not change more
than ±10%
3﹒Q shall not
change more than ±20%
-40
℃
-- +125
℃
1﹒Temp：40±2℃
2﹒R.H.：90 -- 95%
3﹒Time：96±2 hours
1﹒Temp：-25±2℃
2﹒Time：96±2 hours
Room temp
15 mins
Room temp
15 mins
Thermal shock test
-40±2℃
30 mins
+125±2℃
30 mins
Dry heat test
High temperature
load life test
Humidity load life
There shall be no
evidence of short or
open circuiting
Total：5 cycles
1﹒Temp：85±2℃
2﹒Time：96±2 hours
1﹒Temp：85±2℃
2﹒Time：1000±12 hours
3﹒Load：Allowed DC current
1﹒Temp：40±2℃
2﹒R.H.：90 -- 95%
3﹒Time：1000±12 hours
4﹒Load：Allowed DC current
Note：
Unless otherwise specified , Allow the specimen to stand at room temperature
for 1 hour or more but not more than 2 hours , Measure the electrical and
mechanical performances
AR-001A
ABC [ ABC Taiwan Electronics Corp ]
