Tel: 0044 (0)118 979 1238
Fax: 0044 (0)118 979 1283
E-mail: info@actcrystals.com
SOLDERING of CYLINDER CRYSTALS
Lead wire should be soldered within 5 seconds with the iron having a tip
temperature of less than 270°C. Case temperature should not exceed
150°C
With regard to wave soldering it is recommended that the process is
carried out with the crystal unit set upright on the circuit board. Should the
process be carried out with the crystal unit on its side then steps must be
taken to prevent heat transfer through the can.
Should the whole crystal unit be heated (in a re-flow oven for example) it
will result in amarked deterioration of the performance or even failure to
oscillate. This is due to the internal construction of the crystal unit which
involves the use of solder.
Please note that all parameters can not necessarily be specified in the same device
Customer to Specify : Frequency, Frequency Tolerance, Operating Temperature Range & Load Capacitance
In line with our ongoing policy of product evolvement and improvement, the above specification may be subject to change without notice.
ISO9001: 2000 Registered
For quotations or further information please contact us at:
3 The Business Centre, Molly Millars Lane, Wokingham, Berks, RG41 2EY, UK
http://www.actcrystals.com
Issue : 3 C1 (M4)
Date : 07/09/04
2 of 2