1.3 Absolute maximum ratings. 1/
Supply voltage (V
S
) ......................................................................................
Internal power dissipation ...........................................................................
Input voltage ................................................................................................
Output short-circuit duration ........................................................................
Differential input voltage ..............................................................................
Differential input current ..............................................................................
Storage temperature range .........................................................................
Operating temperature range ......................................................................
Lead temperature (soldering, 60 seconds) ..................................................
Junction temperature range (T
J
) ..................................................................
22
V
500 mW
22
V 2/
Indefinite
0.7
V 3/
25
mA 3/
-65C to +150C
-55C to +125C
+300C
-65C to +150C
Thermal resistance, junction-to-case (
JC
) .................................................. See MIL-STD-1835
Thermal resistance, junction-to-ambient (
JA
):
Cases G and H ......................................................................................... 150C/W
Case P ..................................................................................................... 119C/W
Case 2 ...................................................................................................... 110C/W
1.4 Recommended operating conditions.
Supply voltage (V
S
) .....................................................................................
4.5
V to
18
V
Source resistor (R
S
) .................................................................................... 50
Ambient operating temperature range (T
A
) ................................................. -55C to +125C
1.5 Radiation features:
Device type 02:
Maximum total dose available (dose rate = 50 – 300 rads(Si)/s) ................. 100 krads (Si) 4/
Device type 03:
Maximum total dose available (dose rate
10 m rads(Si)/s) ....................... 50 krads (Si) 5/
_____
1/ Stresses above the absolute maximum rating may cause permanent damage to the device. Extended operation at the
maximum levels may degrade performance and affect reliability.
2/ For supply voltages less than
22
V, the absolute maximum input voltage is equal to the supply voltages.
3/ The device inputs are protected by back-to-back diodes. Current limiting resistors are not used in order to achieve low
noise. If differential input voltage exceeds
0.7
V, the input current should be limited to 25 mA.
4/ These parts may be dose rate sensitive in a space environment and may demonstrate enhanced low dose rate effects.
Radiation end point limits for the noted parameters are guaranteed only for the conditions as specified in MIL-STD-883,
method 1019, condition A.
5/ For device type 03, radiation end point limits for the noted parameters are guaranteed for the conditions specified in
MIL-STD-883, test method 1019, condition D.
STANDARD
MICROCIRCUIT DRAWING
DLA LAND AND MARITIME
COLUMBUS, OHIO 43218-3990
DSCC FORM 2234
APR 97
SIZE
A
REVISION LEVEL
5962-94680
SHEET
E
3