Series AMLB-Z
Up to 700mA | Step Up LED Driver
General Specifications
Parameters
Operating frequency
Conditions
Depending on the model
AMLB-3615Z
AMLB-3625Z; AMLB-3630Z
AMLB-3635Z
AMLB-3650Z
AMLB-3660Z; AMLB-3670Z
Typical
360-380
Maximum
Units
KHz
o
Operating temperature
Storage temperature
Maximum case temperature
Thermal Impedance
Cooling
Humidity
Case material
Weight
Dimensions
(L x W x H)
MTBF
Maximum Soldering Temperature
NOTES:
-40 to +85
-40 to +80 (Vin 9-18V) / -40 to +85 (Vin 18-36V)
-40 to +75 (Vin 9-18V) / -40 to +85 (Vin 18-36V)
-40 to +70 (Vin 9-18V) / -40 to +80 (Vin 18-36V)
-40 to +70 (Vin 9-18V) / -40 to +75 (Vin 18-36V)
-55 to +125
100
Depending on the model
+13.7 to +17
Free air convection
95
Non-Conductive Black Plastic (UL94-V0 rated)
38
2.03 x 1.03 x 0.62 inches
51.50 x 26.10 x 15.80 mm
> 860 000hrs (MIL-HDBK-217 F at +25
o
C/Vin=9V,Vout=38V)
1.5mm from case for 10sec.
260
C
C
C
o
C/W
o
o
% RH
g
o
C
1. To prevent burning out the driver, the output voltage must be 5.0VDC higher than the input voltage
2. Do NOT exceed the maximum power ratings on each model
3.
With output ripple being rather low, it is recommended not to increase the additional output capacitor so s not to increase the delay while starting up
under cool start conditions
4. This series offers protection in case the output is shorted. After the short occurs, thDe input current will be cut off and recovers when the short is removed
5. The reference value of under voltage protection (7.6V) means that under the condition of cool start and full discharge of output, the protection starts when
input voltage is lower than 7.6V
6. Note: PWM dimming means PWM signals are converted into mimic analog voltage by internal circuits and then do the dimming. The advantage of this
approach is to reduce the EMI
Safety Specifications
Parameters
Standards
NOTE: Designed to meet EN 55022 Class B, IEC/EN 60950-1 , UL8750, IEC/EN 61347-2-13
Pin Out Specifications
Pin
1
2
3
4
5
6
Single
+Vi
DIM
ON/OFF
-Vi
+LED
-LED
+ DC Supply
PWM/Analog Dimming Control
Remote ON/OFF
-DC Supply
LED Anode connection
LED Cathode connection
www.aimtec.com
F 051e R12.A
Tel: +1 514 620 2722
2 of 7
Toll free: + 1 888 9 AIMTEC
(924 6832)
North America only