Series AMSRL-78-NZ
Up to 7.5 Watt | DC-DC Converter
Application Circuit
V Input
1
AMSRL-78XX-NZ
10
7&9
6
5
V Output
10uF
50V
C1
R1
C2
C3
100uF
20V
ON/OFF
C5
470 uf
R2
Ground
Model Number
AMSRL-783.3-NZ
AMSRL-7805-NZ
AMSRL-7812-NZ
AMSRL-7815-NZ
Ground
C2 (uF)
22
22
10
10
It is recommended that ceramic capacitors are used for C2 & C3.
It is recommended to install C3 to improve performance.
C1 & C2 are required and should be installed as close to the converter as possible
Model Number
AMSRL-783.3-NZ
Nominal
Output (V)
3.3
Vout Adjusted Up
R2 (KΩ)
Vout Adjusted Down
R1 (KΩ)
AMSRL-7805-NZ
5
AMSRL-7812-NZ
12
AMSRL-7815-NZ
15
If it is needed to adjust the output voltage higher or lower than the converter’s nominal value use the equations in the table
above to calculate appropriate resistor values, insuring that the voltage is within the adjustment range for the converter used.
If no voltage adjustment is needed connect a 470uF ceramic capacitor from pin 6 to ground.
NOTE: 1.
Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled
by Aimtec; refer to www.aimtec.com for the most current product specifications.
2.
Product labels shown, including safety agency certifications on labels, may vary based on the
date manufactured.
3.
Mechanical drawings and specifications are for reference only.
4.
All specifications are measured at an ambient temperature of 25°C, humidity<75%,
nominal input voltage and at rated output load unless otherwise specified.5..Aimtec may not have conducted destructive testing or chemical analysis on all internal components
and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release.
5.
This
product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which necessitate
specific safety and regulatory standards other the ones listed in this datasheet.
www.aimtec.com
F 051e R8.B
Tel: +1 514 620 2722
3 of 3
Toll free: + 1 888 9 AIMTEC
(924 6832)
North America only