High Current, High Efficiency Charge Pump
General Description
The AAT3174 is a high output current, high effi-
ciency, low noise, low profile charge pump DC/DC
converter. The device is ideal for multi-functional
LED photo-flash applications where solution cost,
size, and efficiency are critical.
The AAT3174 is capable of driving a regulated out-
put current up to 800mA. Output current levels can
be easily programmed in 16 steps through
AnalogicTech's Simple Serial Control™ (S
2
Cwire™)
interface controlled by a single microcontroller
GPIO line. This allows smooth transitions and flexi-
ble adjustment of brightness in flash or other light-
ing modes. The maximum output current can also
be set with an external R
SET
resistor.
The tri-mode (1X/1.5X/2X) operation of the internal
charge pump offers excellent power efficiency
throughout the output current range for both flash
and movie modes. Combined with a low external
parts count (two 1µF flying capacitors and two
small bypass capacitors at V
IN
and OUT), the
AAT3174 is ideally suited for small battery-pow-
ered applications.
The AAT3174 has a thermal management system to
protect the device in the event of a short-circuit con-
dition at the output pin. Built-in soft-start circuitry pre-
vents excessive inrush current during start-up. The
shutdown feature disconnects the load from V
IN
and
reduces quiescent current to less than 1µA.
The AAT3174 is available in a Pb-free, thermally-
enhanced 12-pin 3x3mm TDFN package and is spec-
ified over the -40°C to +85°C temperature range.
AAT3174
Features
•
•
•
•
•
•
•
•
•
•
ChargePump
™
Up to 800mA Output Current
Tri-Mode 1X/1.5X/2X in Current Mode
16 Current Steps Set by S
2
Cwire
External R
SET
to Set Maximum Current
<1µA of Shutdown
Small Application Circuit
No Inductors
Automatic Soft Start
12-Pin TDFN 3x3mm Package
-40°C to +85°C Temperature Range
Applications
•
•
•
•
•
Camcorders
Camera Phones
Digital Still Cameras
PDAs and Notebook PCs
Smart Phones
Typical Application
C1
1µF
C2
1µF
C1+
V
IN
(2.7V to 5.5V)
VIN
C
IN
4.7µF
C1- C2+
C2-
OUT
C
OUT
2.2µF
Flash
LED
AAT3174
Enable or
S
2
Cwire
EN/SET
RSET
GND
FL
3174.2006.05.1.2
1
ANALOGICTECH [ ADVANCED ANALOGIC TECHNOLOGIES ]
