Model BD2326L50200A00
Rev C
Mounting Configuration:
In order for Xinger surface mount components to work optimally, the proper impedance transmission lines must be
used to connect to the RF ports. If this condition is not satisfied, insertion loss, Isolation and VSWR may not meet
published specifications.
All of the Xinger components are constructed from ceramic filled PTFE composites which possess excellent electrical
and mechanical stability having X and Y thermal coefficient of expansion (CTE) of 17 ppm/
o
C.
An example of the PCB footprint used in the testing of these parts is shown below. An example of a DC-biased
footprint is also shown below. In specific designs, the transmission line widths need to be adjusted to the unique
dielectric coefficients and thicknesses as well as varying pick and place equipment tolerances.
No Bias Footprint
6X .013
[0.34]
DC Bias Footprint
6X .013
[0.34]
2X .006
[0.16]
Part Orientation (Top View)
.012
[0.31]
DC Bias
Part Orientation (Top View)
6X .011
[0.29]
6X .011
[0.29]
6X .002
[0.05]
3X Transmission
Line
Circuit Pattern
Footprint Pad (s)
Solder Resist
Dimensions are in Inches [Millimeters]
0603 Standaard Mounting Footprint
6X .002
[0.05]
.012
[0.31]
Plated thru
holes to
ground
Plated thru
holes to
ground
3X Transmission
Line
Circuit Pattern
Footprint Pad (s)
Solder Resist
2X .006
[0.16]
Dimensions are in Inches [Millimeters]
0603 DC Bias Mounting Footprint
USA/Canada:
Toll Free:
Europe:
(315) 432-8909
(800) 411-6596
+44 2392-232392
Available on Tape and
Reel for Pick and Place
Manufacturing.
ANAREN [ ANAREN MICROWAVE ]
