�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½
�½�½�½�½
�½ �½ �½ �½ �½ �½ �½ �½ �½ �½ �½ �½ �½ �½ �½
�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½�½
INTRODUCTION
This easy-to-use kit provides a platform for the evaluation of
PWM amplifiers using the SA08 pin-out configuration. It can be
used to analyze a multitude of standard or proprietary circuit
configurations, and is flexible enough to do most standard
amplifier test configurations.
The schematic is shown in Figure 3. Note that all of the
components shown on the schematic will probably not be used
for any single circuit. Some components will simply be omitted,
while others require installation of a jumper to complete the
signal path.
Only components unique to the EK15 are provided in this kit.
Hardware similar to that shown in Figure 1 must be obtained
locally.
PARTS LIST
Description
Quantity
Heatsink
1
PC mount Cage Jacks
1 Bag/12 each
PC Board
1
Spacer Grommets
4
Thermal Washer
1 Box/10 each
1µF Cap ST2225B105K501LLXW 2
Novacap
OX7R105KWN 1µF Cap 1825B105K201N,
1
Novacap
TS01
Terminal Strip 66505
1
Beau Interconnect
EC01
470 µf Cap
1
United Chemi-Con
82DA471M500MG2D
HS22
Heatsink
2
Thermolly 6025B
CSR03
0.010 ohm resistor
2
Caddock MP916-0.010 - 5%
CSR04
0.020 ohm resistor
2
Caddock MP930-0.020 - 5%
Apex Part #
HS18
MS04
EVAL19
60SPG00001
TW05
ZX7R105KTL
BEFORE YOU GET STARTED
* All Apex amplifiers should be handled using proper ESD
precautions.
* Always use the heatsink included in this kit with TW05
washer.
* Always use adequate power supply bypassing.
* Do not change connections while the circuit is powered.
* Initially set all power supplies to the minimum operating levels
allowed in the device data sheet.
* Check for oscillations.
FIGURE 1.
APEX MICROTECHNOLOGY CORPORATION • TELEPHONE (520) 690-8600 • FAX (520) 888-3329 • ORDERS (520) 690-8601 • EMAIL prodlit@apexmicrotech.com
1