PM600 SERIES
Single and dual output
•
•
•
•
•
•
24 pin DIP package
1.25 x 0.8 x 0.4 inch package
Tight regulation
Pi input filter
20mV pk-pk ripple and noise
Short circuit protection
[ 2 YEAR WARRANTY ]
The PM600 Series are a broad line of low cost, high performance single and
dual output DC/DC converters packaged in an IC compatible 24 pin DIP
configuration. These miniature converters are ideal for use on high density PC
boards, or wherever low power, isolated and regulated outputs are required. A
self contained input Pi network filter, available on all models, minimizes reflected
ripple current for critical applications. This feature eliminates the need for
external filters thus reducing overall system cost. The PM600 series maintain
±0.3% line and ±0.4% load regulation, and require no derating over the
specified operating temperature range. Other specifications include: output
voltage accuracy, ±5.0%; ripple and noise, 20mV pk-pk; isolation, 300VDC.
PM600 series DC/DC converters are intended for a wide variety of industrial
applications, especially where tight regulation is required.
SPECIFICATION
OUTPUT SPECIFICATIONS
Voltage accuracy
Line regulation
Load regulation
Ripple and noise
Transient response
Temperature coefficient
Short circuit protection
All specifications are typical at nominal input, full load at 25°C unless otherwise stated
GENERAL SPECIFICATIONS
±5.0%, max.
Efficiency
Isolation voltage
Switching frequency
Case material
Weight
MTBF
(75% FL)
Single Outputs
Dual Outputs
Variable
UL94V-0
50% typical
300VDC
40kHz to 70kHz
Non-conductive
black plastic
14g (0.5oz)
434,000 hours
268,000 hours
LL to HL
NL to FL
20MHz BW
See Note 5
Overshoot for
10% to 90% FL
±0.3%
±0.4%
20mV pk-pk, max.
±0.1%, typical
±0.01%°C, typical
Output thermal
limited
Continuous
automatic recovery
ENVIRONMENTAL SPECIFICATIONS
Thermal performance
Operating ambient
–25°C to +71°C
Non-operating amb., –40°C to +125°C
Case
+95°C, max.
Derating
None required
Cooling
Free air convection cooled
Non-condensing
Operating
Non operating
5Hz to 500Hz
20% to 95% RH
10,000 feet max.
40,000 feet max.
2.5G rms (approx.)
INPUT SPECIFICATIONS
Input voltage range
Input filter
Fault current mode
5VDC, See Note 10
4.5 to 5.5VDC
12VDC, See Note 10 10.8 to 13.2VDC
See Note 8
Pi network
150% of FL
input current
Relative humidity
Altitude
Vibration
PAGE 1
ARTESYN [ ARTESYN TECHNOLOGIES ]
