AMMC-6241
26–43 GHz Low Noise Amplifier
Data Sheet
Chip Size: 1900 x 800 mm (74.8 x 31.5 mils)
Chip Size Tolerance: ± 10 mm (± 0.4 mils)
Chip Thickness: 100 ± 10 mm (4 ± 0.4 mils)
RF Pad Dimensions: 110 x 90 mm (4.3 x 3.5 mils)
DC Pad Dimensions: 100 x 100 mm (3.9 x 3.9 mils)
Description
Avago Technologies AMMC-6241 is a high gain, low-
noise amplifier that operates from 26 GHz to 43 GHz.
This LNA provides a wide-band solution for system
design since it covers several bands, thus, reduces part
inventory. The device has input / output match to 50
Ohm, is unconditionally stable and can be used as
either primary or sub-sequential low noise gain stage.
By eliminating the complex tuning and assembly
processes typically required by hybrid (discrete-FET)
amplifiers, the AMMC-6241 is a cost-effective
alternative in the 26 - 43 GHz communications
receivers. The backside of the chip is both RF and DC
ground. This helps simplify the assembly process and
reduces assembly related performance variations and
costs. It is fabricated in a PHEMT process to provide
exceptional noise and gain performance. For improved
reliability and moisture protection, the die is passivated
at the active areas.
Features
•
Wide frequency range: 26 - 43 GHz
•
High gain: 20 dB
•
Low 50
Ω
Noise Figure: 2.7 dB
•
50
Ω
Input and Output Match
•
Flat Gain Response
•
Single 3V Supply Bias
Applications
•
Microwave Radio systems
•
Satellite VSAT, DBS Up/Down Link
•
LMDS & Pt-Pt mmW Long Haul
•
Broadband Wireless Access
(including 802.16 and 802.20 WiMax)
•
WLL and MMDS loops
•
Commercial Grade Military
AMMC-6241 Absolute Maximum Ratings
[1]
Symbol
V
d
V
g
I
d
P
in
T
ch
T
stg
T
max
Parameters/Conditions
Positive Drain Voltage
Gate Supply Voltage
Drain Current
CW Input Power
Operating Channel
Temp.
Storage Case Temp.
Maximum Assembly
Temp (60 sec max)
Units
V
V
mA
dBm
°C
°C
°C
-65
Min.
Max.
7
NA
100
15
+150
+150
+300
Note: These devices are ESD sensitive.
The following precautions are strongly
recommended. Ensure that an ESD
approved carrier is used when dice are
transported from one destination to
another. Personal grounding is to be
worn at all times when handling these
devices.
For more details, refer to Avago Technologies
Application Note A004R:
Electrostatic Discharge Damage and Control.
ESD Machine Model (Class A)
ESD Human Body Model (Class 0)
Note: Operation in excess of any one of these conditions may result in
permanent damage to this device.
AVAGO [ AVAGO TECHNOLOGIES LIMITED ]
