BCM5324M
®
SINGLE-CHIP L2+ MANAGED SWITCH WITH 24 10/100 PORTS + 2 GbE PORTS
FEATURES
•
Seventh-generation ROBO L2+ 24FE + 2GE switch with two
GMII/RGMII/TBI interfaces
SUMMARY OF BENEFITS
•
The BCM5324M includes:
-
-
-
-
-
•
Twenty-four fully integrated 10/100 PHYs with support of
•
QoS packet classification supports four priority queues
•
Port-based VLAN and 802.1Q VLAN with 4k entries
•
Supports traffic aggregation via double tagging
•
Spanning Tree (IEEE 802.1D/1s/1w)
•
MAC-based trunking with automatic link failover
•
Port mirroring
•
IGMP snooping Layer2/3
•
Over 70 MIB counters for per port management statistics
•
Up to 24 Static Secure MAC addresses per port
Advanced Cable Diagnostics in the Broadcom PHY technology
24 10/100 transceivers for TX/FX
24 media access controllers
Two Gigabit media access controllers
3 Mb total of packet buffer and control memory
Non-blocking switch fabric supports up to 24 FE+2 GE
ports
•
Advanced Cable Diagnostics minimize the need for expensive
cable troubleshooting equipment.
•
Enables a new generation of lower cost FE switches with the
highest integration of enhanced L2+ features and maximum
connectivity.
•
Optimized for WebSmart™ managed switch design.
•
802.1Q VLAN allows segmentation of network into smaller
broadcast domains to preserve bandwidth and increase
network security.
•
Programmable Broadcast, Multicast, and Unknown Unicast
storm control
•
Per port bandwidth/rate control
•
8K MAC addresses with automatic learning and aging
•
Protected port
•
Multicast address table for 256 entries
th
•
25 FE port via MII or reversed MII mode for management
•
Four flexible Class of Service (CoS) queues per port assures
the lowest latency to high-priority traffic. This enables the
switch to support a wide variety of delay sensitive video and
audio multicast applications.
and provides redundancy of a link.
•
IEEE 802.3ad link aggregation increases effective bandwidth
•
IEEE 802.1X Extensive Authentication Protocol over LAN
•
Storm and bandwidth/rate control provide better traffic
profile management.
interfaces.
(EAPOL) plus MAC address locking enhances network port
security.
•
MDC/MDIO and SPI interfaces
•
Internal oscillator simplifies design and reduces cost
•
JTAG
•
Embedded 2.5V and 1.2V regulator, typical power
consumption: 3.5W
•
Access to all internal registers through SPI or MDC/MDIO
•
Hardware support for implementing SNMP and RMON.
•
Low-power consumption and small package allow simple PCB
design.
•
400-pin PBGA package