PS2501-1,-2,-4, PS2501L-1,-2,-4
NOTES ON HANDLING
1. Recommended soldering conditions
(1) Infrared reflow soldering
• Peak reflow temperature
260°C or below (package surface temperature)
• Time of peak reflow temperature
• Time of temperature higher than 220°C
10 seconds or less
60 seconds or less
• Time to preheat temperature from 120 to 180°C 120±30 s
• Number of reflows
• Flux
Three
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
Recommended Temperature Profile of Infrared Reflow
(heating)
to 10 s
260˚C MAX.
220˚C
to 60 s
180˚C
120˚C
120±30 s
(preheating)
Time (s)
(2) Wave soldering
• Temperature
• Time
260°C or below (molten solder temperature)
10 seconds or less
• Preheating conditions
• Number of times
• Flux
120°C or below (package surface temperature)
One (Allowed to be dipped in solder including plastic mold portion.)
Rosin flux containing small amount of chlorine (The flux with a maximum chlorine
content of 0.2 Wt% is recommended.)
(3) Soldering by soldering iron
• Peak temperature (lead part temperature)
• Time (each pins)
350°C or below
3 seconds or less
• Flux
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
(a) Soldering of leads should be made at the point 1.5 to 2.0 mm from the root of the lead.
(b) Please be sure that the temperature of the package would not be heated over 100°C.
13
Data Sheet PN10225EJ02V0DS
CEL [ CALIFORNIA EASTERN LABS ]
