PS2865-1
NOTES ON HANDLING
1. Recommended soldering conditions
(1) Infrared reflow soldering
• Peak reflow temperature
235 °C or below (package surface temperature)
• Time of temperature higher than 210 °C
• Number of reflows
30 seconds or less
Three
• Flux
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt % is recommended.)
Recommended Temperature Profile of Infrared Reflow
(heating)
to 10 s
235 ˚C (peak temperature)
210 ˚C
to 30 s
100 to 160 ˚C
60 to 120 s
(preheating)
Time (s)
(2) Dip soldering
• Temperature
• Time
260 °C or below (molten solder temperature)
10 seconds or less
• Number of times
• Flux
One (Allowed to be dipped in solder including plastic mold portion.)
Rosin flux containing small amount of chlorine (The flux with a maximum chlorine content of
0.2 Wt % is recommended.)
(3) Cautions
• Fluxes
Avoid removing the residual flux with freon-based and chlorine-based cleaning solvent.
2. Cautions regarding noise
Be aware that when voltage is applied suddenly between the photocoupler’s input and output or between
corrector-emitters at startup, the output side may enter the on state, even if the voltage is within the absolute
maximum ratings.
8
Data Sheet PN10259EJ01V0DS
CEL [ CALIFORNIA EASTERN LABS ]
