CL9P5LQ
Epoxy-encapsulated Photoconductors
(Replaces the CL9P5L)
®
Clairex
November, 2003
Technologies, Inc
.
Pattern shown is
typical and may vary
from part to part.
ALL DIMENSIONS ARE IN INCHES
features
•
thicker ceramic substrate
•
low cost epoxy encapsulation
absolute maximum ratings
(T
A
= 25°C unless otherwise stated)
storage and operating temperature …………………………………….-50°C to +75°C
lead soldering temperature
(1)
……………………………………………………….260°C
power dissipation at 25°C air temperature……………………………………….50mW
1.
2.
0.06” (1.5mm) from the case for 5 seconds maximum.
The CL9P5LQ has a 0.079” thick substrate and 1.0” minimum length leads.
The CL9P5L had a 0.055” thick substrate and 1.4” minimum length leads.
description
The CL9P5LQ consists of CdS
base material deposited on a
ceramic substrate and epoxy
encapsulated. The CL9P5LQ is
electrically equivalent to, and
replaces, the CL9P5L and CL905L.
For applications assistance, call
Clairex.
`
notes:
electrical characteristics
(T
A
= 25°C unless otherwise noted)
Part
Number
CL9P5LQ
Material
Type
CdS,CdSe
R
ON(1)(2)
Ω(typ)
10K
R
OFF(3)
Ω
(min.)
670K
V
meas(4)
Volts
10
V
(max)
Volts
100
notes
:
1. On-resistance (R
ON
) is measured at 2 ft-c after light stabilization at 30 ft-c for 16 hours minimum just prior to test.
2.
3.
4.
R
ON
tolerance is
±33%
at 2 ft-c.
Light source for all R
ON
measurements is an unfiltered tungsten source operating at a color temperature of
2854K.
Off-resistance (R
OFF
) is measured under dark conditions, 5 seconds after R
ON
test. A dark condition is reached
when the value of R
OFF
can not be increased by further irradiation shielding.
Measurement voltage (V
meas
) is the steady-state bias applied to the device for measurement of R
ON
and R
OFF
.
Clairex reserves the right to make changes at any time to improve design and to provide the best possible product.
Revised 3/15/06
Clairex Technologies, Inc.
Phone: 972-265-4900
1301 East Plano Parkway
Fax: 972-265-4949
Plano, Texas 75074-8524
www.clairex.com
CLAIREX [ CLAIREX TECHNOLOGIES, INC ]
