Mechanical Dimensions
Document No. SPE/LP476PBG1-90G-03
All dimensions are in mm. Tolerance is ±0.25 mm unless otherwise noted.
Rev. No.
02
An epoxy meniscus may extend about 1.5 mm down the leads.
Dimen
be 0.5 mm max.
Burr around bottom of epoxy may
sion Draw ing
maximum
ating
Unit
mA
mA
V
mW
30
00
5
32
~ +100
°C
°C
~ +100
0
°C
for
Notes
Max.
3 sec
RoHS Compliance
e base of the epoxy bulb)
The levels of environmentally sensitive, persistent biologically toxic (PBT), persistent organic pollutants (POP), or
otherwise restricted materials in this product are below the maximum concentration values (also referred to as the
threshold limits) permitted for such substances, or are used in an exempted application, in accordance with EU Direc-
=
2002/95/EC on the restriction of the use of certain hazardous substances in electrical and electronic equipment
Ta
tive
25 )
(RoHS), as amended through April 21, 2006.
cs (
°C
Vision Advisory Claim
Users
at the
Condition
should be cautioned not to stare
Typ.
light of this LED product. The bright light can damage the eye.
Min.
Max.
Unit
I
F
= 30mA
4
V
R
= 5V
---
CLD-CT20.000
---
3.6
---
4.4
100
V
A
Copyright © 2007 Cree, Inc. All rights reserved. The information in this document is subject to change without notice. Cree and the
Cree logo are registered trademarks of Cree, Inc.
Cree, Inc.
4600 Silicon Drive
Durham, NC 27703
USA Tel: +1.919.313.5300
Fax: +1.919.313.5778
www.cree.com/ledlamps
CREE [ CREE, INC ]
