Con tact
•
Sharp points
allow contact
to pierce tough insulation
materials
•
Contact tines are firmly
connected
to the body of
the contact
•
No “bare shoulders”
on
the contact at the PC board
interface.
•
Spring temper, phosphor
bronze material
resists
breakage during bending
or straightening
operations
•
One tail length
can be
used with 1/8 in. or 1/16 in.
PC boards
•
Rounded tip provides
lead-in
to mate with PC
board holes
PCB Con n ector Featur es
•
10, 20, 26, 34, 40, 50, 60, pin versions
•
Tin-lead plating, standard; gold plating also available
•
Available with or without strain relief lip
•
Available with or without cover lip for cable end or daisy
chain application
•
Rugged, lightweight UL 94V-0 thermoplastic construction
•
Accepts 28-30 AWG stranded or solid conductors
PCB Connectors
Str ain Relief
A molded-in strain relief is an optional feature on CW PCB
connectors. (Specify CWR-140 or CWR-143 series). This
lip, upon installation of the cover, creates a strain relief
bend in the cable, inhibiting the transfer of any tension on
the cable to the contact lines.
Cover Lip
For additional protection on cable end terminations, the
CW PCB connector is available with a cover lip to insulate
the ends of the cable’s conductors. This eliminates
possible “shorts” and allows you to position connectors
more closely on your PC board. (Specify CWR-140 or
CWR-141 series).
Assembly
To terminate CW PCB connectors to flat cable, use
CT301 86/81 assembly press. The cable is applied directly
to the IDC contacts in the connector base
and then the cover
is assembled.
•
130 James Way, Southampton, PA 18966 - 3838
•
Telephone: (215) 355-7080
•
Fax: (215) 355-1088
•
www.cwind.com
35