DS1073
3V EconOscillator/Divider
www.maxim-ic.com
FEATURES
§
§
§
§
§
§
§
§
§
§
§
Dual fixed-frequency outputs (30kHz to
100MHz)
User-programmable on-chip dividers (from 1
to 513)
User-programmable on-chip prescaler (1, 2,
4)
No external components
±0.5%
initial tolerance (commercial)
±1%
variation over commercial temperature
and voltage
Internal clock, external clock or crystal
reference options
2.7 to 3.6V supply
Power-down mode
Synchronous output gating
Industrial temp operation with relaxed
specifications
PIN ASSIGNMENT
I/O
OUT0
V
CC
GND
1
2
3
4
8
7
6
5
OSCIN
XTAL
OE
PDN/SELX
DS1073Z-XXX 150-mil SOIC
DS1073M-XXX 300-mil DIP
XXX = Frequency option
FREQUENCY OPTIONS
Part No.
DS1073M/Z-100
DS1073M/Z-80
DS1073M/Z-66
DS1073M/Z-60
Max O/P Freq.
100.000MHz
80.000MHz
66.667MHz
60.000MHz
DESCRIPTION
The DS1073 is a fixed-frequency oscillator requiring no external components for operation. Numerous
operating frequencies are possible in the range of approximately 27.3kHz to 100MHz through the use of
an on-chip programmable prescaler and divider.
The DS1073 features a master oscillator followed by a prescaler and then a programmable divider. The
prescaler and programmable divider are user-programmable with the desired values being stored in non-
volatile memory. This allows the user to buy an off the shelf component and program it on site prior to
board production. Design changes can be accommodated on the fly by simply programming different
values into the device (or reprogramming previously programmed devices).
The DS1073 is shipped from the factory configured for half the maximum operating frequency. Contact
the factory for specially programmed devices. As alternatives to the onboard oscillator an external clock
signal or a crystal may be used as a reference. The choice of reference source (internal or external) is
user-selectable at the time of programming (or on the fly if the SEL mode is chosen).
The DS1073 features a dual-purpose I/O pin. If the device is powered up in Program mode this pin can be
used to input serial data to the on chip registers. After a Write command this data is stored in non-volatile
memory. When the chip is subsequently powered up in operating mode these values are automatically
restored to the on-chip registers and the I/O pin becomes the oscillator output.
The DS1073 may be operated over either the commercial (T
A
= 0C to 70C) or industrial (T
A
= -40C to +
85C) temperature ranges. AC and DC Electrical Characteristics Tables for operation in both these
temperature ranges are given at the end of the data sheet.
1 of 18
090503
DALLAS [ DALLAS SEMICONDUCTOR ]
