DS1267
LINEARITY MEASUREMENT CONFIGURATION
Figure 5
NOTE:
In this setup, a ±2% delta in total resistance R0 to R1 would cause a ±2.5 MI error.
DS1267 ABSOLUTE AND RELATIVE LINEARITY
Figure 6
TYPICAL APPLICATION CONFIGURATIONS
Figures 7 and 8 show two typical application configurations for theDS1267. By connecting the wiper
terminal of the part to a high-impedance load, the effects of the wiper resistance is minimized, since the
wiper resistance can vary from 400 to 1000ohms depending on wiper voltage. Figure 7 presents the
device connected in an inverting variable gain amplifier. The gain of the circuit on Figure 7 is given by
the following equation:
Av = -n/(255-n); where n = 0 to 255
Figure 8 shows the device operating in a fixed gain attenuator where the potentiometer is used to
attenuate an incoming signal. Note the resistance R1 is chosen to be much greater than the wiper
resistance to minimize its effect on circuit gain.
6 of 12
102199
DALLAS [ DALLAS SEMICONDUCTOR ]
