EN25F05
EN25F05
512 Kbit Serial Flash Memory with 4Kbytes Uniform Sector
FEATURES
•
Single power supply operation
- Full voltage range: 2.7-3.6 volt
•
Serial Interface Architecture
- SPI Compatible: Mode 0 and Mode 3
•
512 Kbit Serial Flash
- 512 K -bit/ 64 K-byte/ 256 pages
- 256 bytes per programmable page
•
High performance
- 100MHz clock rate
•
Low power consumption
- 12 mA typical active current
- 1
µA
typical power down current
•
-
-
-
Uniform Sector Architecture:
16 sectors of 4-Kbyte
2 blocks of 32-Kbyte
Any sector or block can be
erased individually
•
Software and Hardware Write Protection:
- Write Protect all or portion of memory via
software
- Enable/Disable protection with WP# pin
•
-
-
-
-
High performance program/erase speed
Page program time: 1.5ms typical
Sector erase time: 150ms typical
Block erase time 800ms typical
Chip erase time: 1 Seconds typical
•
Lockable 256 byte OTP security sector
•
Minimum 100K endurance cycle
•
-
-
-
Package Options
8 pins SOP 150mil body width
8 contact VDFN
All Pb-free packages are RoHS compliant
•
Industrial temperature Range
GENERAL DESCRIPTION
The EN25F05 is a 512K-bit (64K-byte) Serial Flash memory, with advanced write protection
mechanisms, accessed by a high speed SPI-compatible bus. The memory can be programmed 1 to 256
bytes at a time, using the Page Program instruction.
The EN25F05 is designed to allow either single
Sector/Block
at a time or full chip erase operation. The
EN25F05 can be configured to protect part of the memory as the software protected mode. The device
can sustain a minimum of 100K program/erase cycles on each sector
or block.
This Data Sheet may be revised by subsequent versions
or modifications due to changes in technical specifications.
2
©2004 Eon Silicon Solution, Inc.,
www.eonssi.com
Rev. D, Issue Date: 2010/04/15
EON [ EON SILICON SOLUTION INC. ]
