EN25Q16A
EN25Q16A
16 Megabit Serial Flash Memory with 4Kbyte Uniform Sector
FEATURES
•
Single power supply operation
- Full voltage range: 2.7-3.6 volt
•
Serial Interface Architecture
- SPI Compatible: Mode 0 and Mode 3
•
16 Mbit Serial Flash
- 16 M-bit/2048 K-byte/8192 pages
- 256 bytes per programmable page
•
-
-
-
•
-
-
-
Standard, Dual or Quad SPI
Standard SPI: CLK, CS#, DI, DO, WP#
Dual SPI: CLK, CS#, DQ
0
, DQ
1
, WP#
Quad SPI: CLK, CS#, DQ
0
, DQ
1
, DQ
2
, DQ
3
High performance
104MHz clock rate for one data bit
80MHz clock rate for two data bits
80MHz clock rate for four data bits
•
Software and Hardware Write Protection:
- Write Protect all or portion of memory via
software
- Enable/Disable protection with WP# pin
•
-
-
-
-
High performance program/erase speed
Page program time: 1.3ms typical
Sector erase time: 60ms typical
Block erase time 400ms typical
Chip erase time: 12 seconds typical
•
Lockable 512 byte OTP security sector
•
Minimum 100K endurance cycle
•
-
-
-
-
-
Package Options
8 pins SOP 150mil body width
8 pins SOP 200mil body width
8 contact VDFN
8 pins PDIP
All Pb-free packages are RoHS compliant
•
Low power consumption
- 12 mA typical active current
- 1
μA
typical power down current
•
-
-
-
Uniform Sector Architecture:
512 sectors of 4-Kbyte
32 blocks of 64-Kbyte
Any sector or block can be erased individually
•
Industrial temperature Range
GENERAL DESCRIPTION
The EN25Q16A is a 16-Megabit (2048K-byte) Serial Flash memory, with advanced write protection
mechanisms. The EN25Q16A supports the standard Serial Peripheral Interface (SPI), and a high
performance Dual/Quad output as well as Dual/Quad I/O using SPI pins: Serial Clock, Chip Select,
Serial DQ
0
(DI), DQ
1
(DO), DQ
2
(WP#) and DQ
3
(NC). SPI clock frequencies of up to 80MHz are
supported allowing equivalent clock rates of 160MHz for Dual Output and 320MHz for Quad Output
when using the Dual/Quad Output Fast Read instructions. The memory can be programmed 1 to 256
bytes at a time, using the Page Program instruction.
The EN25Q16A is designed to allow either single
Sector/Block
at a time or full chip erase operation. The
EN25Q16A can be configured to protect part of the memory as the software protected mode. The
device can sustain a minimum of 100K program/erase cycles on each sector
or block
.
This Data Sheet may be revised by subsequent versions
or modifications due to changes in technical specifications.
1
©2004 Eon Silicon Solution, Inc.,
www.eonssi.com
Rev. E, Issue Date: 2011/07/14