EN25QH16
EN25QH16
16 Megabit Serial Flash Memory with 4Kbyte Uniform Sector
FEATURES
•
Single power supply operation
- Full voltage range: 2.7-3.6 volt
•
Serial Interface Architecture
- SPI Compatible: Mode 0 and Mode 3
•
16 M-bit Serial Flash
- 16 M-bit/2,048 K-byte/8,192 pages
- 256 bytes per programmable page
•
-
-
-
•
-
-
-
Standard, Dual or Quad SPI
Standard SPI: CLK, CS#, DI, DO, WP#, HOLD#
Dual SPI: CLK, CS#, DQ
0
, DQ
1
, WP#, HOLD#
Quad SPI: CLK, CS#, DQ
0
, DQ
1
, DQ
2
, DQ
3
High performance
104MHz clock rate for Standard SPI
80MHz clock rate for two data bits
80MHz clock rate for four data bits
•
Software and Hardware Write Protection:
- Write Protect all or portion of memory via
software
- Enable/Disable protection with WP# pin
•
-
-
-
-
High performance program/erase speed
Page program time: 1.3ms typical
Sector erase time: 60ms typical
Block erase time 400ms typical
Chip erase time: 12 seconds typical
•
Lockable 512 byte OTP security sector
•
Support Serial Flash Discoverable
Parameters (SFDP) signature
•
Read Unique ID Number
•
Minimum 100K endurance cycle
•
Package Options
- 8 pins SOP 150mil body width
- 8 pins SOP 200mil body width
- 8 contact VDFN (5x6mm)
- 8 pins PDIP
- 24 balls TFBGA (6x8mm)
•
Low power consumption
- 12 mA typical active current
- 1
μA
typical power down current
•
-
-
-
Uniform Sector Architecture:
512 sectors of 4-Kbyte
32 blocks of 64-Kbyte
Any sector or block can be erased individually
- All Pb-free packages are RoHS compliant
•
Industrial temperature Range
GENERAL DESCRIPTION
The EN25QH16 is a 16 Megabit (2,048 K-byte) Serial Flash memory, with enhanced write protection
mechanisms. The EN25QH16 supports the standard Serial Peripheral Interface (SPI), and a high
performance Dual/Quad output as well as Dual/Quad I/O using SPI pins: Serial Clock, Chip Select,
Serial DQ
0
(DI), DQ
1
(DO), DQ
2
(WP#) and DQ
3
(HOLD#). SPI clock frequencies of up to 80MHz are
supported allowing equivalent clock rates of 160MHz (80MHz x 2) for Dual Output and 320MHz
(80MHz x 4) for Quad Output when using the Dual/Quad I/O Fast Read instructions. The memory can
be programmed 1 to 256 bytes at a time, using the Page Program instruction.
The EN25QH16 is designed to allow either single
Sector/Block
at a time or full chip erase operation.
The EN25QH16 can be configured to protect part of the memory as the software protected mode. The
device can sustain a minimum of 100K program/erase cycles on each sector
or block
.
This Data Sheet may be revised by subsequent versions
©2004 Eon Silicon Solution, Inc.,
1
or modifications due to changes in technical specifications.
Rev. H, Issue Date: 2012/01/30
www.eonssi.com