EN25QH16-104QIP 参数 Datasheet PDF下载

EN25QH16

OPERATING FEATURES

Standard SPI Modes

The EN25QH16 is accessed through a SPI compatible bus consisting of four signals: Serial Clock

(CLK), Chip Select (CS#), Serial Data Input (DI) and Serial Data Output (DO). Both SPI bus operation

Modes 0 (0,0) and 3 (1,1) are supported. The primary difference between Mode 0 and Mode 3, as

shown in Figure 3, concerns the normal state of the CLK signal when the SPI bus master is in standby

and data is not being transferred to the Serial Flash. For Mode 0 the CLK signal is normally low. For

Mode 3 the CLK signal is normally high. In either case data input on the DI pin is sampled on the rising

edge of the CLK. Data output on the DO pin is clocked out on the falling edge of CLK.

Figure 3. SPI Modes

Dual SPI Instruction

The EN25QH16 supports Dual SPI operation when using the “Dual Output Fast Read and Dual I/O

Fast Read “ (3Bh and BBh) instructions. These instructions allow data to be transferred to or from the

Serial Flash memory at two to three times the rate possible with the standard SPI. The Dual Read

instructions are ideal for quickly downloading code from Flash to RAM upon power-up (code-shadowing)

or for application that cache code-segments to RAM for execution. The Dual output feature simply

allows the SPI input pin to also serve as an output during this instruction. When using Dual SPI

instructions the DI and DO pins become bidirectional I/O pins; DQ

0

and DQ

1

. All other operations use

the standard SPI interface with single output signal.

Quad SPI Instruction

The EN25QH16 supports Quad output operation when using the Quad I/O Fast Read (EBh).This

instruction allows data to be transferred to or from the Serial Flash memory at four to six times the rate

possible with the standard SPI. The Quad Read instruction offer a significant improvement in

continuous and random access transfer rates allowing fast code-shadowing to RAM or for application

that cache code-segments to RAM for execution. The EN25QH16 also supports full Quad Mode

function while using the Enable Quad Peripheral Interface mode (EQPI) (38h). When using Quad SPI

instruction the DI and DO pins become bidirectional I/O pins; DQ

0

and DQ

1,

and the WP# and HOLD#

pins become DQ

2

and DQ

3

respectively.

This Data Sheet may be revised by subsequent versions

©2004 Eon Silicon Solution, Inc.,

8

or modifications due to changes in technical specifications.

Rev. H, Issue Date: 2012/01/30

www.eonssi.com