EN29F010
The system must write the Erase Resume command (address bits are “don’t care”) to exit the
erase suspend mode and continue the sector erase operation. Further writes of the Resume command
are ignored. Another Erase Suspend command can be written after the device has resumed erasing.
Sector Protection/Unprotection
The hardware sector protection feature disables both program and erase operations in any sector. The
hardware sector unprotection feature re-enables both program and erase operations in previously
protected sectors.
Sector protection/unprotection must be implemented using programming equipment. The procedure re-
quires a high voltage (V
ID
) on address pin A9 and the control pins.
Contact Eon Silicon Solution, Inc. for
an additional supplement on this feature.
This Data Sheet may be revised by subsequent versions
or modifications due to changes in technical specifications.
10
©2003 Eon Silicon Solution, Inc., www.essi.com.tw
Rev. A, Issue Date: 2003/10/20
EON [ EON SILICON SOLUTION INC. ]
