EP3001 Evaluation Board Manual
DESCRIPTION
This manual aims to illustrate how to use the EP3001 Evaluation Board (“EP3001 EVB”).
The EP3001 EVB is a constant-frequency buck regulator, using the EP3001, 1.5MHz, 600mA
Synchronous Step-down Converter. The EP3001 EVB is available for input voltage range from 2.5V to
5.5V. The EP3001 EVB is capable of delivering up to 600mA of output current at minimum input voltage
of 3V, or even up to 800mA under certain specific condition.
This manual includes Quick Start for using the EP3001 EVB, Demonstration Circuit, PCB Layout and
Bill of Material for the EP3001 EVB.
QUICK START
The EP3001 EVB is easy to set up to evaluate the performance of the EP3001. For proper measurement
equipment setup, please follow the explanation below:
Fixed Voltage Type
1. Connect the power supply to the Vin and GND terminals, respectively, on the right side of the EVB.
(Do
NOT
hot-plug Vin or increase Vin over the rated maximum supply voltage of 6V, or the part may
be damaged.)
2. Connect the load between the Vout and GND terminals, respectively.
3. Connect the required measurement equipments, refer to Figure 1.
4. Turn on the power supply.
5. Measure Vin, Vout, Iin and Iout.
Adjustable Type
1. Select the shunt at JP4 for different output voltage.
IF the Vout required is not listed in the EVB, please see Output Programming section.
2. Connect the power supply to the Vin and GND terminals, respectively, on the right side of the EVB.
(Do
NOT
hot-plug Vin or increase Vin over the rated maximum supply voltage of 6V, or the part may
be damaged.)
3. Connect the load between the Vout and GND terminals, respectively.
4. Connect the required measurement equipments, refer to Figure 1.
5. Turn on the power supply.
6. Measure Vin, Vout, Iin and Iout.
Rev.01
1/4
EOREX [ EOREX CORPORATION ]
