Technical Data Sheet
3mm POWER LED
30-01/T4C-4PRB
6. Soldering Condition
Careful attention should be paid during soldering. When soldering, leave more then 3mm
from solder joint to case, and soldering beyond the base of the tie bar is recommended.
Avoiding applying any stress to the lead frame while the LEDs are at high temperature
particularly when soldering.
Recommended soldering conditions:
Hand Soldering
Temp. at tip of iron
Soldering time
Distance
400
℃
Max. (30W Max.)
3 sec Max.
3mm Min.(From solder joint
to case)
Distance
3mm Min.
Preheat temp.
Bath temp.
Bath time.
DIP Soldering
100
℃
Max. (60 sec Max.)
265 Max.
5 sec Max.
EVERLIGHT ELECTRONICS CO., LTD.
Office: No 25, Lane 76, Sec 3, Chung Yang Rd,
Tucheng, Taipei 236, Taiwan, R.O.C
Tel: 886-2-2267-2000, 2267-9936
Fax: 886-2267-6244, 2267-6189, 2267-6306
http:\\www.everlight.com
Everlight Electronics Co., Ltd.
Device Number :DLE-300-091
http:\\www.everlight.com
Establish date: 04-27-2007
Rev. 1
Page: 8 of 8
Establish by: Jim Lin
EVERLIGHT [ EVERLIGHT ELECTRONICS CO., LTD ]
