EVERLIGHT ELECTRONICS CO., LTD.
Technical Data Sheet - Preliminary
High Performance SMD LED with Reflector
93-22SURSYGC/S530-A3/TR8
4. Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3 seconds
within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals,
and do soldering of each terminal. Be careful because the damage of the product is often started
at the time of the hand solder.
5. Repairing
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a
double-head soldering iron should be used (as below figure). It should be confirmed beforehand
whether the characteristics of the LEDs will or will not be damaged by repairing.
EVERLIGHT ELECTRONICS CO., LTD.
Office: No 25, Lane 76, Sec 3, Chung Yang Rd,
Tucheng, Taipei 236, Taiwan, R.O.C
Tel: 886-2-2267-2000, 2267-9936
Fax: 886-2267-6244, 2267-6189, 2267-6306
http://www.everlight.com
Everlight Electronics Co., Ltd
Device No.: DSE-932-032
http://www.everlight.com
Prepared date: 20-Nov-2007
Rev. 1.1
Page: 11 of 11
Prepared by: Josh Chou
EVERLIGHT [ EVERLIGHT ELECTRONICS CO., LTD ]
