MP7616
ELECTRICAL CHARACTERISTICS (CONT’D)
NOTES:
1
Full Scale Range (FSR) is 10V for unipolar mode.
2
Guaranteed but not production tested.
3
Digital input levels should not go below ground or exceed the positive supply voltage, otherwise damage may occur.
4
Specified values guarantee functionality. Refer to other parameters for accuracy.
5
Linearity error is degraded by 65µV for every mV of voltage offset at output amplifier.
6
Output leakage current refers to I
OUT1
. One LSB of current constantly flows into I
OUT2
(30nA at 5kΩ input impedance,
V
REF
= +10 V) due to ladder termination into I
OUT2
.
Specifications are subject to change without notice
ABSOLUTE MAXIMUM RATINGS (T
A
= +25
°
C unless otherwise noted)
1, 2
V
DD
to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0 to +17 V
Digital Input Voltage to GND . . . . GND –0.5 to V
DD
+0.5 V
I
OUT1
, I
OUT2
to GND . . . . . . . . . . . GND –0.5 to V
DD
+0.5 V
V
REF
to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +25 V
V
RFB
to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +25 V
Storage Temperature . . . . . . . . . . . . . . . . . –65
°
C to +150
°
C
Lead Temperature (Soldering, 10 seconds) . . . . . . +300
°
C
Package Power Dissipation Rating to 75
°
C
CDIP, PDIP, SOIC . . . . . . . . . . . . . . . . . . . . . . . . 1000mW
Derates above 75
°
C . . . . . . . . . . . . . . . . . . . . . 13mW/
°
C
NOTES:
1
Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a
stress rating only and functional operation at or above this specification is not implied. Exposure to maximum rating
conditions for extended periods may affect device reliability.
2
Any input pin which can see a value outside the absolute maximum ratings should be protected by Schottky diode clamps
(HP5082-2835) from input pin to the supplies.
APPLICATION NOTES
Refer to Section 8 for Applications Information
Rev. 2.00
4
EXAR [ EXAR CORPORATION ]
