FTLF1424P2xCL and FTLF1424P2xCV SFP Product Specification – December 2006
Finisar
11. Measured with conformance signals defined in FC-PI-2 Rev. 10.0 specifications. Represents
sensitivity based on OMA spec, as corrected to incoming Extinction Ratio of 13 dB (for example, at
5.75dB incoming extinction ratio, an OMA of 0.029 mW corresponds to -16 dBm sensitivity).
Measured with PRBS 2
7
-1 at 10
-12
BER .
12. Rate Selectable version in low bandwidth mode with minimum 9dB extinction ratio.
13. Rate Selectable version in low bandwidth mode.
14. Rate Selectable version in high bandwidth mode.
V.
General Specifications
Parameter
Symbol
BR
BER
L
MAX1
L
MAX2
Min
1062
Typ
Max
4250
10
-12
Units
Ref.
Mb/sec 1
2
km
3
km
3
Data Rate
Bit Error Rate
Max. Supported Link Length on
9/125
μm
SMF @ 4X Fibre Channel
Max. Supported Link Length on
9/125μm SMF @ 1X and 2X Fibre
Channel
Max. Supported Link Length on
9/125μm SMF @ Gigabit Ethernet
30
30
L
MAX3
30
km
3
Notes:
1. Gigabit Ethernet and 1x/2x/4x Fibre Channel compliant.
2. Tested with a PRBS 2
7
-1 test pattern.
3.
Distances are based on FC-PI-2 Rev. 10.0 and IEEE 802.3 standards.
VI.
Environmental Specifications
These Finisar 1310nm Commercial Temperature SFP transceivers have an operating
temperature range from –10°C to +70°C case temperature.
Parameter
Case Operating Temperature
Storage Temperature
Symbol
T
op
T
sto
Min
-10
-40
Typ
Max
70
85
Units
°C
°C
Ref.
VII.
Regulatory Compliance
Finisar transceivers are Class 1 Laser Products and comply with US FDA regulations.
These products are certified by TÜV and CSA to meet the Class 1 eye safety
requirements of EN (IEC) 60825 and the electrical safety requirements of EN (IEC)
60950. Copies of certificates are available at Finisar Corporation upon request.
©
Finisar Corporation December 18, 2006 Rev A Page 5