FWLF-1631-XX DWDM SFP Preliminary Product Specification – August 2005
Finisar
VI. Wavelength Stabilization
The laser transmitter will not be turned on until its temperature is adjusted to ensure
operation within the specified channel (X +/- 0.4nm). This temperature stabilization time is
dependent on the ambient temperature conditions, but will typically occur within 30
seconds of powering the device. The device will transmit within the specified wavelength
tolerance (X +/- 0.1nm) within 5 seconds of transmitter operation.
VII. General Specifications
Parameter
Data Rate
Total System Budget
Symbol
BR
Min
0.155
28
Typ
Max
2.7
Units Notes/Conditions
Gb/sec SONET OC-3/12/48 compatible
30
dB @ 2.5 Gb/s, BER <10
-12
w/
PRBS 2
-23
-1. See Note 1
Note 1: Total system budget is defined as P
out
– P
in
– typical connector losses.
VIII. Environmental Specifications
Parameter
Operating Temp
Symbol
T
op
Min
-5
Typ
Max
70
Units Notes/Conditions
°C
Case temperature measured on top-side of
device
Storage Temp
T
sto
-10
85
°C Ambient temperature
Eye Safety
CDRH and IEC-825 Class 1 Laser
Product. See Note 1
Note 1: Complies with FDA performance standards for laser products except for deviations pursuant to
Laser Notice No. 50, dated July 26, 2001.
©
Finisar Corporation
Rev B, August 2005
PRELIMINARY and Confidential
Page 7
FINISAR [ FINISAR CORPORATION. ]
