FWLF1634Ryxx DWDM SFP Preliminary Product Specification – February 2009
Finisar
VI. Wavelength Stabilization
The laser transmitter will not be turned on until its temperature is adjusted to ensure
operation within the specified channel (X +/- 300pm). This temperature stabilization time is
dependent on the ambient temperature conditions, but will typically occur within 5 seconds
of powering the device. The module will transmit within the specified wavelength tolerance
(X +/- 100pm) within 10 ms of transmitter operation.
VII. General Specifications
Parameter
Data Rate
Total Link Budget
Total Link Budget
Symbol
BR
Min
0.155
26
31
Typ
Max
4.25
30
34
Units Notes/Conditions
Gb/sec SONET OC-3/12/48 compatible
dB @ 4.25 Gb/s, BER <10
-12
w/
PRBS 2
7
-1. See Note 1
dB @ 2.5 Gb/s, BER <10
-12
w/ PRBS
2
23
-1. See Note 1
Note 1: Total link budget is defined as P
out
– P
in
– typical connector losses. Operating in low rate mode
VIII. Environmental Specifications
Parameter
Operating Temp
Storage Temp
Eye Safety
Symbol
T
op
T
sto
Min
-5
-40
Typ
Max
70
85
Units Notes/Conditions
°C
°C
Case temperature measured on top-side of
device
Ambient temperature
CDRH and IEC-825 Class 1 Laser
Product. See Note 1
Note 1: Complies with FDA performance standards for laser products except for deviations pursuant to Laser Notice No.
50, dated July 26, 2001.
©
Finisar Corporation
Rev C2, Feb.2009
PRELIMINARY
Page 7