Signals/Connections
Table 1-5.
Signal Name
PINIT/NMI
Input
Phase Lock Loop Signals (Continued)
Signal Description
PLL Initial/Non-Maskable Interrupt
During assertion of RESET, the value of PINIT/NMI is written into the PLL
Enable (PEN) bit of the PLL control register, determining whether the PLL is
enabled or disabled. After RESET deassertion and during normal instruction
processing, the PINIT/NMI Schmitt-trigger input is a negative-edge-triggered
Non-Maskable Interrupt (NMI) request internally synchronized to CLKOUT.
PINIT/NMI can tolerate 5 V.
Type
State During
Reset
Input
1.5 External Memory Expansion Port (Port A)
Note:
When the DSP56301 enters a low-power stand-by mode (Stop or Wait), it releases bus mastership and tri-
states the relevant Port A signals:
A[0–23]
,
D[0–23]
,
AA0/RAS0
–
AA3/RAS3
,
RD
,
WR
,
BB
,
CAS
,
BCLK
, and
BCLK
. If hardware refresh of external DRAM is enabled, Port A exits the Wait mode to allow the refresh to
occur and then returns to the Wait mode.
1.5.1
External Address Bus
Table 1-6.
External Address Bus Signals
Signal Description
Address Bus
When the DSP is the bus master, A[0–23] specify the address for external
program and data memory accesses. Otherwise, the signals are tri-stated. To
minimize power dissipation, A[0–23] do not change state when external
memory spaces are not being accessed.
Signal Name
A[0–23]
Type
Output
State During
Reset
Tri-stated
1.5.2
External Data Bus
Table 1-7.
External Data Bus Signals
Signal Description
Data Bus
When the DSP is the bus master, D[0–23] provide the bidirectional data bus
for external program and data memory accesses. Otherwise, D[0–23] are tri-
stated.
Signal Name
D[0–23]
Type
Input/Output
State During
Reset
Tri-stated
DSP56301 Technical Data, Rev. 10
1-6
Freescale Semiconductor
FREESCALE [ FREESCALE SEMICONDUCTOR, INC ]
