Document Reference No.: FT_000247
V2-EVAL Vinculum II Evaluation Board Datasheet Version 2.0
Clearance No.: FTDI#148
5.11
LED enable/disable jumpers JP10 – JP14.
Figure 5.16
LED Enable/Disable jumpers
Every user-defined LED have an enable/disable jumper. When jumper is closed LED will be illuminate
when driven low by one of the VNC2 pins. When jumper is opened LED is disconnected from the VCN2
pin.
Designator
JP7
LED affected
LED3
JP8
LED4
JP9(41)
LED5
JP10
LED6
Notes:
(41) When running VNC1L migrated firmwares on 48-pin package, the jumper JP9 must be
removed, thus disabling this LED.
Table 5.16 LED Enable/Disable Jumpers.
5.12
User push button switches
Figure 5.17
User Push Button Switches
Push button switches connected straight to VNC2 pins. When the switch is pressed down,
a logic LOW appears on the corresponding VNC2 pin.
VNC2 Pin Number
Designator
32-PIN
48-PIN
64-PIN
14
SW3(42)
SW4(42)
SW5(42)
15
-
14
48
32
-
42
48
SW6(42)
-
43
49
Notes:
(42) The IOBUS pins are shared by other connectors on the board. Care should be taken to
ensure that operation of the switches does not interfere with pins used by other headers
on the board.
Table 5.17 User Switches
Copyright © 2010 Future Technology Devices International Limited
30
FTDI [ FUTURE TECHNOLOGY DEVICES INTERNATIONAL LTD. ]
