MB89202 Series
7. Flash Content Protection
Flash content can be read using parallel / serial programmer if the flash content protection mechanism is not
activated.
One predefined area of the flash (FFFC
H
) is assigned to be used for preventing the read access of flash content.
If the protection code "01
H
" is written in this address (FFFC
H
), the flash content cannot be read by any parallel/
serial programmer.
Note : The program written into the flash cannot be verified once the flash protection code is written ("01
H
" in
FFFC
H
). It is advised to write the flash protection code at last.
■
PROGRAMMING TO THE EPROM WITH EVALUATION PRODUCT DEVICE
1. EPROM for Use
MBM27C256A (DIP-28)
2. Memory Space.
Normal operating mode
Address
0000
H
I/O
0080
H
RAM 512 bytes
0280
H
Not available
Corresponding adresses on the
ROM programmer
Address
8000
H
0000
H
PROM 32 Kbytes
EPROM 32 Kbytes
FFFF
H
7FFF
H
3. Programming to the EPROM
(1) Set the EPROM programmer to the MBM27C256A.
(2) Load program data into the EPROM programmer at 0000
H
to 7FFF
H
.
(3) Program to 0000
H
to 7FFF
H
with the EPROM programmer.
13