Programming
specifications
requirements for
intelligent system
control panels:
The number of devices that can
have their LEDs programmed to
illuminate is limited by the fea-
tures of the panel and the indi-
vidual devices. The actual num-
ber of devices is determined by
the control panel and its
ability to supply LED cur-
rent. Refer to the control
panel installation manual
for details.
SS-PD: Current Requirem ents (us ing no access ories)
Pow e r
24VAC, 120VAC, 220/240 VAC,
Supply
30-30VDC
50/60 Hz 50/60 Hz
50/60 Hz
Voltage
Max.
65 mA
44 mA
25 mA RMS
Standby
26 Ma
RMS
RMS
Current
Max Alarm
182 mA
52 mA
87 mA
30 mA RMS
Current
RMS
RMS
Alarm
3 to 17
3 to 17
3 to 17
Response
3 to 17 Sec.
Sec.
Sec.
Sec.
Tim e
Pow e r Up
2 Sec.
2 Sec.
2 Sec.
2 Sec.
Tim e
Specifications
SS-PD
Operating voltage range
15 to 32 VDC.
Standby current
300 µA @ 24 VDC (one communi-
cation every 5 seconds with LED
blink enabled).
Operating temperature range
32° to 131°F (0° to 55°C).
Relative Humidity range
10% to 93% (non-condensing).
Duct air velocity
100 to 4,000 feet/min (0.5 to 20.32
m/s).
Dimensions
14.750" (37 cm) length x 5.500" (14
cm) width x 2.750" (7 cm) deep.
Options
1. RTS-451, RTS-451KEY, RA400Z.
2. PA400
(Review installation instruc-
tions on power requirements)
.
SS-PDR: Relay Contact Ratings
10 Amp @ 30 VDC
Alarm
Auxiliary
Contacts *
(DPDT)
Supervisory
Contact
(SPST)
10 Amp @ 277 VAC (0.75 Pow er Factor)
240 VAC @ 249 VAC (0.4 Pow er Factor)
1/8 HP @ 120 VAC
1/4 HP @ 240 VAC
2.0 Amp @ 30 VDC (resistive)
Minimum sw itching current of 100 mA @ 5 VDC.
Product Line
Information
Model
SS-PD
SS-PDR
A5053GM
A5067
A5060
ST-1.5
ST-3
ST-5
ST-10
RA400Z
RTS451
Description
Duct detector housing with SmartScan™
photoelectric smoke detector.
Duct detector housing with SmartScan™
photoelectric smoke detector, DPDT relay.
Replacement photoelectric sensor board.
Replacement power board (without relay).
Replacement power board (with relay).
Metal sampling tube, duct widths 1' to 2'
(see
table at left for metric lengths).
Metal sampling tube, duct widths 2' to 4'.
Metal sampling tube, duct widths 4' to 8'.
Metal sampling tube, duct widths 8' to 12'.
Remote annunciator alarm LED.
Remote test station. Mounts in single-gang
box. Includes red alarm LED and magnet
test switch.
Key-activated remote test station.
Replacement filters.
Replacement test magnet.
Replacement photo insect screen.
SS-PDR
Operating voltage range
20 to 30 VDC, 24 VAC/VDC, 120/
240 VAC auxiliary power
(requires
a separate auxiliary source).
Standby current
300 µA @ 24 VDC (one communi-
cation every 5 seconds with LED
blink enabled).
Operating temperature range
32° to 131°F (0° to 55°C).
Relative Humidity range
10% to 93% (non-condensing).
Duct air velocity
100 to 4,000 feet/min (0.5 to
20.32 m/s).
Dimensions
14.750" (37 cm) length x 5.500" (14
cm) width x 2.750" (7 cm) deep.
Options
1. RTS-451, RTS-451KEY, RA400Z.
2. PA400
(Review installation instruc-
tions on power requirements).
The RA400Z
The RTS451
RTS451KEY
F36-09-11
M02-04-00
S08-39-01
The RTS451KEY
Page 2 of 4
SS-PD and SS-PDR
CS-2463
10/21/04
GAMEWELL-FCI [ GAMEWELL-FCI BY HONEYWELL ]
