600 Series
SAN, SAN-RC
Description
The 600 Series serial annunciator driver (SAN) is used to
light a lamp or LED in an annunciator. It also provides a
switched positive output per point for interface with building
automation systems or driving relays. Each device is capa-
ble of interpreting the instructions from the main CPU, initi-
ating its own programmed response, and retransmitting the
instructions to the next device.
The Gamewell-FCI 600 systems can accommodate up to
64 devices connected to the serial communications port. In
addition to the serial annunciator drives (SAN), these
devices include remote annunciator (RAN) and remote
printer interface (RPI). This combination of devices com-
prise the Gamewell-FCI status control network. Since each
device contains its own microprocessor, each can be pro-
grammed independently. A series of devices can be pro-
grammed directly over the network from a single device,
saving valuable installation time. Programming is accom-
plished via Windows
®
-based configuration software.
Each SAN input point can activate up to five output points
for matrix annunciation. There are two basic models avail-
able, the SAN and the SAN-RC. The SAN-16 is equipped
with 16 freely programmable outputs which can be used for
remote control or monitoring, expandable to 128 points
using PDM modules.
The SAN-16-RC has all of the features of the SAN-16, plus
the ability to read inputs into the system. The SAN-16-RC
has provisions for four inputs for: remote acknowledge,
reset, signal silence, and lamp test. In addition to the basic
16 outputs, there are eight (8) common outputs for: com-
mon system alarm, common system trouble, AC power,
communications, action required LED prompts for system
acknowledge, reset and signal silence, and a driver for a
local audible.
The status control network, including SAN units, is con-
nected to the main 600 Series control panel via an RS-232
data communication line. The SIM-232 module is used to
Microsoft
®
Windows
®
is a registered trademark of Microsoft
®
Corporation.
gwf2027ph1.wmf
Serial Annunciator Driver
SAN, SAN-RC
Features
•
Up to 64 devices supported on a single 600 Series
control panel.
Windows
®
-based field programming.
Dual optically isolated serial ports.
Can interface with building automation systems
via standard ASCII communication.
Microprocessor based.
Expandable in 16 point increments to 128 points.
Supervised.
Allows remote system control.
Mounting track included.
•
•
•
•
•
•
•
An ISO 9000-2000 Company
SIGNALING
S521
7120-1288:149
GAMEWELL-FCI
Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use.
©2007 Honeywell International Inc. All rights reserved.
www.gamewell-fci.com
CS-2027 Rev. A page 1 of 2
12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: (203) 484-7161 • Fax: (203) 484-7118
GAMEWELL-FCI [ GAMEWELL-FCI BY HONEYWELL ]
