GENLINX
™
II
GS9025A
Serial Digital Receiver
PRELIMINARY DATA SHEET
FEATURES
• SMPTE 259M compliant
• operational to 540Mb/s
• automatic cable equalization (typically greater than
350m of high quality cable at 270Mb/s)
• adjustment-free operation
• auto-rate selection (5 rates) with manual override
• single external VCO resistor for operation with five
input data rates
• data rate indication output
• serial data outputs muted and serial clock remains
active when input data is lost
• operation independent of SAV/EAV sync signals
• signal strength indicator output
• carrier detect with programmable threshold level
• power savings mode (output serial clock disable)
APPLICATIONS
Cable equalization plus clock and data recovery for all high
speed serial digital interface applications involving SMPTE
259M and other data standards.
DESCRIPTION
The GS9025A provides automatic cable equalization and
high performance clock and data recovery for serial digital
signals. The GS9025A receives either single-ended or
differential serial digital data and outputs differential clock
and retimed data signals at PECL levels (800mV). The on-
board cable equalizer provides up to 40dB of gain at
200MHz which typically results in equalization of greater
than 350m of high quality cable at 270Mb/s.
The GS9025A operates in either auto or manual data rate
selection mode. In both modes, the GS9025A requires only
one external resistor to set the VCO centre frequency and
provides adjustment free operation.
The GS9025A has dedicated pins to indicate signal
strength/carrier detect, LOCK and data rate. Optional
external resistors allow the carrier detect threshold level to
be customized to the user's requirement. In addition, the
GS9025A provides an 'Output Eye Monitor Test'
(OEM_TEST) for diagnostic testing of signal integrity after
equalization, prior to reslicing. The serial clock outputs can
also be disabled to reduce power. The GS9025A operates
from a single +5 or -5 volt supply.
ORDERING INFORMATION
PART NUMBER
GS9025ACQM
GS9025ACTM
PACKAGE
44 pin MQFP Tray
44 pin MQFP Tape
TEMPERATURE
0°C to 70°C
0°C to 70°C
GS9025A
A/D
DDI
DDI
ANALOG
DIGITAL
MUX
CARRIER DETECT
PHASELOCK
HARMONIC
C
OSC
LOCK
LOGIC
MUTE
SDO
SDI
SDI
+
-
-
VARIABLE
GAIN EQ
STAGE
FREQUENCY
ACQUISITION
PHASE
DETECTOR
SDO
CLK_EN
SCO
SCO
OEM_TEST
EYE
MONITOR
DIVISION
AUTO EQ
CONTROL
CHARGE
PUMP
3 BIT
COUNTER
SMPTE
AUTO/MAN
SS0
SS1
SS2
+
-
AGC CAP CD_ADJ
SSI/CD
VCO
DECODER
LF+ LFS LF-
CBG R
VCO
BLOCK DIAGRAM
Revision Date: June 2000
GENNUM CORPORATION P.O. Box 489, Stn. A, Burlington, Ontario, Canada L7R 3Y3
Tel. +1 (905) 632-2996 Fax. +1 (905) 632-5946 E-mail: info@gennum.com
www.gennum.com
Document No. 522 - 75 - 00
GENNUM [ GENNUM CORPORATION ]
