Driver circuits for CCD image sensor
C11287, C11288
Specifications (Typ. Ta=25 °C, unless otherwise noted)
C11287
Parameter
Condition
S10420-
S10420-
S10420- 1006-01, S10420- 1106-01, S11071-
1004-01 S11510- 1104-01 S11510-
1004
1000
1106
250 k
4.8
5.7
8.9
9.8
0.62
4.3
4.3
8.4
8.4
0.22
4.8
5.7
8.9
9.8
0.84
14
12.2
3
5461
USB 2.0
DC + 4.5 to 5.5
-20 to + 70
0 to + 50
70 max.
80 (H) × 70 (W)
Approx. 60
80 (H) × 80 (W)
Approx. 65
C11288
S11071-
1006
S11071-
1104
S11071-
1106
Unit
Scanning
Frame readout time
Data transfer time
Total transfer time
A/D conversion resolution 16383ADU
Conversion gain
Readout noise
Dynamic range
Interface
C11287
360 mA typ.
Supply voltage
C11288
650 mA typ.
Storage temperature
Operating temperature
Operating humidity
No condensation
Dimension
Weight
4M
1.58
0.22
1.80
0.79
0.44
1.23
1.75
0.44
2.19
Hz
ms
bit
e-/ADU
ADU
-
-
V
°C
°C
%
mm
g
7
2730
Functions
Parameter
Suspend mode (LED-off)
Operating Standby mode (LED-white)
mode setting Data transfer mode
(LED-green, aqua, blue)
Internal synchronous mode
("INT" mode)
Selectable
External synchronous mode 1
data
("EXT.EDGE" mode)
acquisition
modes
External synchronous mode 2
("EXT.LEVEL" mode)
Gain adjustment
Offset adjustment
Pulse output signal setting
Specification
The power supply is turned off.
It is Standby state, in which the data acquisition is possible.
In this mode, the driver circuit sends the data to PC.
Data is acquired on the basis of the trigger timing generated by application software.
Data is acquired in synchronization with the external trigger signal input from the
BNC connector. In synchronization with an edge of the external trigger signal, data is
accumulated for the set integration time and is then output.
Data is acquired in synchronization with the external trigger signal input from the BNC
connector. Data is accumulated for a period equal to the pulse width of the external
trigger signal and is then output.
The gain value can be varied in the range of “1 to 10” with the step of 1. Default value is
"1".
The offset value can be varied in the range of “0 to 1020” with the step of 4. Default
value is "40".
It is possible to set the timing of the pulse output signal that is output from the “BNC
connector for pulse output” of the driver circuit.
2
HAMAMATSU [ HAMAMATSU CORPORATION ]
