sFeatures
of DF11 Insulation Displacement Machine
(Single Core Punching Full Automatic ID Machine AM700/DF11)
q
5 Major Features of ID Machine AM700/DF11
1. Perform the multi-harness.
2. The setup time has been widely reduced. (10 minutes maximum)
3. Space saving design.
(About half space compared with the conventional machine)
4. Minimize initial cost with low cost.
5. The harness data can be saved in the floppy disk and easily
changed.
Data storage
Low cost
Setup in 10 minutes
Multi-harness
Half space
sPoints
Since the DF11 insulation displacemention allows double rows ID with a single part, the harness service is completed with
machine connection only.
sProduct
Specifications
AWG 22 to 26: 2A
Current rating
Rating
(Note 1)
Insulation Displacement Wire size
Voltage rating
Crimping
Crimping
Wire size
AWG 28
AWG 30
AWG 26
: 1A
: 0.5A
: 1A
Storage Temperature Range -10 to 60ç Note 3
40 to 70%
Operating Temperature Range -30 to 85ç Note 2
Operating Humidity Range
40 to 80%
250V AC Insulation Displacement 100V AC Storage Humidity Range
UL-CSA Safety Standard Approved Specification
AWG 22
Rating
Current rating
Voltage rating
Item
1. Insulation Resistance
2. Withstanding voltage
3. Contact Resistance
5. Vibration
1000M
ohms
min.
Wire size
30V AC
Specification
500V DC
AWG 30
: 2A
: 0.5A
AWG 24 to 28: 1A
sUL
·CSA Safety Standard File No.
UL
:E52653
CSA
:LR95109
Condition
650V AC/1 minute
100mA
Measured by the square steel-made pin of 0.5±0.002mm
No flashover or insulation breakdown.
30m
ohms
max.
4. Single Insertion/Extraction Force 0.3N (30gf) min., 4.4N(450gf) min.
No electrical discontinuity of 1µs or more
Frequency: 10 to 55 Hz, single amplitude of 0.75 mm, 2 hours in each of the 3 directions.
96 hours at temperature of 40ç and humidity of 90% to 95%
(-55ç: 30 minutes
➝
15 to 35ç: 2 to 3 minutes
(-85ç:
30 minutes
➝
15 to 35ç: 2 to 3minutes) 5 cycles
Tin plated: 30 cycles
Gold plated:50 cycles
6.
Humidity (Steady state)
Contact resistance: 30m
ohms
max. Insulation resistance: 500M
ohms
min.
7. Temperature Cycle
Contact resistance: 30m
ohms
max. Insulation resistance: 1000M
ohmsmin.
8. Durability (Mating/un-mating) Contact resistance: 30m
ohms
max.
Flow:
9. Resistance to Soldering heat
No deformation of components affecting performance.
Manual soldering:
300ç for 2 seconds
Manual soldering:
250ç for 10 seconds
Reflow:
At the recommended temperature profile 300ç for 3 seconds
Note 1: Includes temperature rise caused by current flow.
Note 2: The term "storage" refers to products stored for long period of time prior to mounting and use. Operating Temperature Range and
Humidity range covers non conducting condition of installed connectors in storage, shipment or during transportation.
A267
HRS [ HIROSE ELECTRIC ]
