The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.
All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.
LX Series●Ultra Low-profile Interface Connectors with 2.0 mm Mounting Height
■Receptacles Recommended Temperature Profile
(ç)
PEAK:250 +5
230ç min.
0
ç
HRS test conditions
250
200
150
100
50
Solder composition
Paste, 96.5%Sn/3.0%Ag/0.5%Cu
Test board
Glass epoxy 35mm x 35mm x 0.8mm thick
180ç
150ç
90 30s
90 10s
The temperature profiles are based on the above
conditions. In individual applications the actual
temperature may vary, depending on solder
paste type, volume/thickness and board
size/thickness. Contact your solder paste and
equipment manufacture for specific
recommendations.
BApplicable Plug Cable
(mm)
Part number
LX40-12P
LX40-16P
LX40-20P
Cable diameter
Wire size
Ø4 max.
Ø4.5 max.
Ø5 max.
Ø0.6 mm max. (AWG 30 to 32 or equivalent)
Note 1: Applicable cable sizes are guidelines. (There may be slight differences depending on the cable outer insulation)
Note 2: Cables must be attached using single piece overmolded bushings on the cable.
Note 3: Please refer to applicable Cable Termination Procedures Manual for correct plug assembly and cable termination.
Note 4: Contact HRS for cable assemblies.
BMated Condition Dimensions
Receptacle
1.4
2
Plug
(mm)
6
HRS [ HRS ]
