iC-WK, iC-WKL
2.4 V CW LASER DIODE DRIVER
Rev D1, Page 7/8
APPLICATION NOTES
Setting the output power
The output power is simply set by RM = V(MDA) /
I(MD); with V(MDA) = Item-No. 101 and I(MD) = mon-
itor current at the desired operating point. RM should
be combined from fixed resistor (max. output power)
and a trimmer (calibration).
Further application notes on
and the data
sheets of the evaluation modules and the demo board
are available as separate documents.
This specification is for a newly developed product. iC-Haus therefore reserves the right to change or update, without notice, any information contained herein,
design and specification; and to discontinue or limit production or distribution of any product versions. Please contact iC-Haus to ascertain the current data.
Copying – even as an excerpt – is only permitted with iC-Haus approval in writing and precise reference to source.
iC-Haus does not warrant the accuracy, completeness or timeliness of the specification on this site and does not assume liability for any errors or omissions
in the materials. The data specified is intended solely for the purpose of product description. No representations or warranties, either express or implied, of
merchantability, fitness for a particular purpose or of any other nature are made hereunder with respect to information/specification or the products to which
information refers and no guarantee with respect to compliance to the intended use is given. In particular, this also applies to the stated possible applications or
areas of applications of the product.
iC-Haus conveys no patent, copyright, mask work right or other trade mark right to this product. iC-Haus assumes no liability for any patent and/or other trade
mark rights of a third party resulting from processing or handling of the product and/or any other use of the product.
ICHAUS [ IC-HAUS GMBH ]
