IS61C632A
IS61C632A
32K x 32 SYNCHRONOUS PIPELINED STATIC RAM
DESCRIPTION
The
ICSI
IS61C632A is a high-speed, low-power synchro-
nous static RAM designed to provide a burstable, high-perfor-
mance, secondary cache for the i486™, Pentium™, 680X0™,
and PowerPC™ microprocessors. It is organized as 32,768
words by 32 bits, fabricated with
ICSI
's advanced CMOS
technology. The device integrates a 2-bit burst counter, high-
speed SRAM core, and high-drive capability outputs into a
single monolithic circuit. All synchronous inputs pass through
registers controlled by a positive-edge-triggered single clock
input.
Write cycles are internally self-timed and are initiated by the
rising edge of the clock input. Write cycles can be from one to
four bytes wide as controlled by the write control inputs.
Separate byte enables allow individual bytes to be written.
BW1
controls DQ1-DQ8,
BW2
controls DQ9-DQ16,
BW3
controls DQ17-DQ24,
BW4
controls DQ25-DQ32, conditioned
by
BWE
being LOW. A LOW on
GW
input would cause all bytes
to be written.
Bursts can be initiated with either
ADSP
(Address Status
Processor) or
ADSC
(Address Status Cache Controller) input
pins. Subsequent burst addresses can be generated internally
by the IS61C632A and controlled by the
ADV
(burst address
advance) input pin.
Asynchronous signals include output enable (OE), sleep mode
input (ZZ), clock (CLK) and burst mode input (MODE). A HIGH
input on the ZZ pin puts the SRAM in the power-down state.
When ZZ is pulled LOW (or no connect), the SRAM normally
operates after three cycles of the wake-up period. A LOW
input, i.e., GND
Q
, on MODE pin selects LINEAR Burst. A V
CCQ
(or no connect) on MODE pin selects INTERLEAVED Burst.
FEATURES
• Fast access time:
– 4 ns-125 MHZ; 5 ns-100 MHz;
6 ns-83 MHz; 7 ns-75 MHz; 8 ns-66 MHz
• Internal self-timed write cycle
• Individual Byte Write Control and Global Write
• Clock controlled, registered address, data and
control
• Pentium™ or linear burst sequence control
using MODE input
• Three chip enables for simple depth expansion
and address pipelining
• Common data inputs and data outputs
• Power-down control by ZZ input
• JEDEC 100-Pin LQFP and PQFP package
• Single +3.3V power supply
• Two Clock enables and one Clock disable to
eliminate multiple bank bus contention.
• Control pins mode upon power-up:
– MODE in interleave burst mode
– ZZ in normal operation mode
These control pins can be connected to GND
Q
or V
CCQ
to alter their power-up state
ICSI reserves the right to make changes to its products at any time without notice in order to improve design and supply the best possible product. We assume no responsibility for any errors
which may appear in this publication. © Copyright 2000, Integrated Circuit Solution Inc.
Integrated Circuit Solution Inc.
SSR001-0B
1
ICSI [ INTEGRATED CIRCUIT SOLUTION INC ]
