IMP51 1 1/51 1 2
IMP52 9
Application Information
Figure 1. Receiving Waveform – 20MHz
Figure 2. Driving Waveform – 20MHz
Receiver
1 Meter, AWG 28
IMP5219
Driver
IMP5219
5219_03.eps
Figure 3.
IMP5219 Maximizes Line Current
Cable transmission theory suggests to optimize signal speed and
quality, the termination should act both as an ideal voltage refer-
ence when the line is released (deasserted) and as an ideal
current source when the line is active (asserted). Common active
terminators which consist of linear regulators in series with resis-
tors (typically 110Ω) are a compromise. With coventional linear
terminators as the line voltage increases the amount of current
decreases linearly by the equation;
Disable/Sleep Mode
Disable mode places the device in a sleep state, where quiescent
current typically 375µA. When disabled, all outputs are in a high
impedance state and output capacitance is a low 3pF. Sleep mode
can be used for power conservation or to remove the terminator
from the SCSI chain.
An additional feature of the IMP5219 is its compatibility with
active negation drivers.
(
V
REF
−
V
LINE
)
=
I.
R
The IMP5219, with its unique new architecture, applies the maxi-
mum amount of current regardless of line voltage until the
termination high threshold (2.85V) is reached.
Acting as a near ideal line terminator, the IMP5219 closely repro-
duces the optimum case when the device is enabled. To enable the
device the Disable pin must be driven HIGH or left Open. When
enabled, quiescent current is 6mA and the device will respond to
line demands by delivering 24mA on assertion and by imposing
2.85V on de-assertion.
Table 1. Power Up/ Power Down Function Table
Disable
H
L
Open
Outputs
Enabled
Disable/High
Impedance
Enabled
Quiescent Current
6mA
375
µA
6mA
5219_t04.eps
4
www.ds-imp.com.cn
Daily Silver IMP
IMP [ IMP, INC ]
