Dimensions LF 205-P
Bottom view
(in mm. 1 mm = 0.0394 inch)
Secondary terminals
Terminal + : supply voltage + 12 .. 15 V
Terminal M : measure
Terminal - : supply voltage - 12 .. 15 V
Front view
Left view
Back view
Connection
Top view
Mechanical characteristics
•
General tolerance
•
Fastening & secondary connection
Recommanded PCB hole
•
Primary through-hole
•
Supplementary fastening
Recommended PCB hole
Recommended screws
LEM code
± 0.2 mm
3 pins 0.63x0.56 mm
∅
0.9 mm
∅
15.5 mm
2 holes
∅
1.75 mm
2.4 mm
KA22 x 6
47.30.60.006.0
Remarks
•
I
S
is positive when
I
P
flows in the direction of the arrow.
•
Temperature of the primary conductor should not exceed
100°C.
•
Dynamic performances (di/dt and response time) are best
with a single bar completely filling the primary hole.
•
This is a standard model. For different versions (supply
voltages, turns ratios, unidirectional measurements...),
please contact us.
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without previous notice.
LEM [ LEM ]
