Advance Data Sheet
November 17, 2011
40A Analog Mega DLynxTM: Non-isolated DC-DC Power Module
4.5 – 14.4Vdc input; 0.6Vdc to 2Vdc output; 40A output current
Design Considerations
Input Filtering
The 40A Analog Mega DLynxTM module should be
connected to a low ac-impedance source. A highly
inductive source can affect the stability of the
module. An input capacitance must be placed
directly adjacent to the input pin of the module, to
minimize input ripple voltage and ensure module
stability.
TBD
To minimize input voltage ripple, ceramic capacitors
are recommended at the input of the module. Figure
1 shows the input ripple voltage for various output
voltages at 40A of load current with TBD µF or TBD
µF ceramic capacitors and an input of 12V.
Figure 2. Output ripple voltage for various output
voltages with external TBD ceramic capacitors at
the output (40A load). Input voltage is 12V.
Safety Considerations
TBD
For safety agency approval the power module must be
installed in compliance with the spacing and
separation requirements of the end-use safety agency
standards, i.e., UL 60950-1 2nd, CSA C22.2 No.
60950-1-07, DIN EN 60950-1:2006 + A11 (VDE0805
Teil 1 + A11):2009-11; EN 60950-1:2006 + A11:2009-
03.
Figure 1. Input ripple voltage for various output
voltages with TBD µF or TBD µF ceramic
capacitors at the input (40A load). Input voltage
is 12V.
For the converter output to be considered meeting the
requirements of safety extra-low voltage (SELV), the
input must meet SELV requirements. The power
module has extra-low voltage (ELV) outputs when all
inputs are ELV.
Output Filtering
These modules are designed for low output ripple
voltage and will meet the maximum output ripple
specification with 0.1 µF ceramic and TBD µF ceramic
capacitors at the output of the module. However,
additional output filtering may be required by the
system designer for a number of reasons. First, there
may be a need to further reduce the output ripple and
noise of the module. Second, the dynamic response
characteristics may need to be customized to a
particular load step change.
The input to these units is to be provided with a fast-
acting fuse with a maximum rating of TBD A in the
positive input lead.
To reduce the output ripple and improve the dynamic
response to a step load change, additional
capacitance at the output can be used. Low ESR
polymer and ceramic capacitors are recommended to
improve the dynamic response of the module. Figure 2
provides output ripple information for different external
capacitance values at various Vo and a full load
current of 40A. For stable operation of the module,
limit the capacitance to less than the maximum output
capacitance as specified in the electrical specification
table. Optimal performance of the module can be
achieved by using the Tunable LoopTM feature
described later in this data sheet.
LINEAGE POWER
6
LINEAGEPOWER [ LINEAGE POWER CORPORATION ]
