LT1013/LT1014
APPLICATIONS INFORMATION
(b) When the input is more than 400mV below ground (at
25°C), the input stage saturates (transistors Q3 and Q4)
and phase reversal occurs at the output. This can cause
lock-up in servo systems. Due to a unique phase reversal
protection circuitry (Q21, Q22, Q27, Q28), the LT1013/
1014’s outputs do not reverse, as illustrated below, even
when the inputs are at –1.5V.
There is one circumstance, however, under which the phase
reversal protection circuitry does not function: when the
other op amp on the LT1013, or one specific amplifier of the
other three on the LT1014, is driven hard into negative
saturation at the output.
Phase reversal protection does not work on amplifier:
A when D’s output is in negative saturation. B’s and C’s
outputs have no effect.
B when C’s output is in negative saturation. A’s and D’s
outputs have no effect.
C when B’s output is in negative saturation. A’s and D’s
outputs have no effect.
D when A’s output is negative saturation. B’s and C’s
outputs have no effect.
At the output, the aforementioned single supply designs
either cannot swing to within 600mV of ground (OP-20) or
cannot sink more than a few microamperes while swing-
ing to ground (LM124, LM158). The LT1013/1014’s
all-NPN output stage maintains its low output resistance
and high gain characteristics until the output is saturated.
In dual supply operations, the output stage is crossover
distortion-free.
Voltage Follower with Input Exceeding the Negative Common-Mode Range
4V
2V
4V
2V
0V
0V
6Vp-p INPUT, – 1.5V TO 4.5V
LM324, LM358, OP-20
EXHIBIT OUTPUT PHASE
REVERSAL
0V
LT1013/LT1014
NO PHASE REVERSAL
Comparator Rise Response Time
10mV, 5mV, 2mV Overdrives
OUTPUT (V)
4
OUTPUT (V)
4
2
INPUT (mV)
0
0
INPUT (mV)
– 100
V
S
= 5V, 0V
50µs/DIV
8
U
W
U
U
Comparator Applications
The single supply operation of the LT1013/1014 lends
itself to its use as a precision comparator with TTL
compatible output:
In systems using both op amps and comparators, the
LT1013/1014 can perform multiple duties; for example,
on the LT1014, two of the devices can be used as op amps
and the other two as comparators.
4V
2V
Comparator Fall Response Time
to 10mV, 5mV, 2mV Overdrives
2
0
100
0
V
S
= 5V, 0V
50µs/DIV
LINER [ LINEAR TECHNOLOGY ]
