Introduction to Circuit Protection
Axial Lead & Cartridge Fuses
Transientology
5×20 mm > Time-Lag > 215 Series
Soldering Parameters -Wave Soldering
300
280
260
240
220
200
180
160
140
120
100
80
Recommended Process Parameters:
Wave Parameter
Preheat:
ꢌ%FQFOETꢀPOꢀ'MVYꢀ"DUJWBUJPOꢀ5FNQFSBUVSFꢏ
Temperature Minimum:
Temperature Maximum:
PreheatTime:
Lead-Free Recommendation
(Typical Industry Recommendation)
100° C
150° C
60-180 seconds
Solder PotTemperature:
Solder DwellTime:
260° C Maximum
2-5 seconds
60
40
20
Recommended Hand-Solder Parameters:
0
Time (Seconds)
Solder IronTemperature: 350° C +/- 5°C
)FBUJOHꢀ5JNFꢃꢀꢀꢅꢀTFDPOETꢀNBYꢐ
Preheat Time
Dwell Time
Cooling Time
Note: These devices are not recommended for IR or
Convection Reflow process.
Different values of A and B available, please contact the Littelfuse sales representative in your region:
B
A
For the pigtailed fuse, please follow the recommendations
below for axial lead forming and mounting into PCB:
C
Lead forming:
The distance C between cap flat surface and axial lead shall
be greater than 1.0 mm.
C
PCB mounting:
The distance between PCB and fuse cap is recommended to
be a minimum of 1.5 mm.
B
Dimensions
Part Numbering System
0215 xxxx M X E P
0215.125P
to
Series
0215020P
Amp Code
Refer to Amp Code column of
Electrical Characteristics Table
0215.125XEP
to
0215.800XEP
Quantity Code
M = 1000
Packaging Code
0215001.XEP
to
X = Filler
0215020.XEP
Option Codes
Blank : Cartidge Type Fuse
E
: Axial Lead Fuse
* Ratings above 6.3 A have 0.8 mm diameter lead;
ratings above 12 A have 1.2 mm diameter lead
Lead-free
© 2012 Littelfuse, Inc.
215 Series
Specifications are subject to change without notice.
Please refer to www.littelfuse.com/series/215.html for current information.
LITTELFUSE [ LITTELFUSE ]
