AT10-0009
Voltage Variable Absorptive
Attenuator, 800 - 1000 MHz
Features
•
•
•
•
•
•
•
•
•
•
Input IP3: +35 dBm Min. (Full Attenuation Range)
Input IP3 is
15 -20 dB
Better Than GaAs
Linear Operation: +20 dBm Typ.
38 dB Dynamic Range (With 30 mA Bias Current)
Single Control Voltage
50 ohm Impedance
Linear Driver, DR65-0002, Available
Test Boards are Available
Tape and Reel Packaging Available
SOW-16 Package
Rev. V9
Functional Schematic
Description
M/A-COM's AT10-0009 is a PIN diode based voltage
variable attenuator. This device is in a SOW-16,
wide body plastic surface mount package. These
attenuators have linear operating power and input
intercept point levels 15 - 20 dB better than GaAs
FET MMIC voltage variable attenuators. They are
ideally suited for use where low distortion, high linear
operating power and high dynamic range are
required. These devices are optimized for the GSM
frequency band, but exhibit excellent performance
and repeatability over the entire specified frequency
band. The AT10-0009 is ideally suited for wireless
communications systems.
Pin Configuration
Pin No.
1
2
3
Function
GND
RF
GND
GND
GND
GND
Bias
1
GND
Pin No.
9
10
11
12
13
14
15
16
Function
GND
RF
GND
GND
GND
GND
Bias
1
GND
Ordering Information
Part Number
AT10-0009
AT10-0009TR
AT10-0009-TB
DR65-0002-TBG
4
5
Package
Bulk Packaging
1000 piece reel
Sample Test Board
Unit with Driver on Test Board
1.
6
7
8
Bias currents may be applied to pin 7 or 15. The unused
pin should be isolated.
Note: Reference Application Note M513 for reel size
information.
1
ADVANCED:
Data Sheets contain information regarding a product M/A-COM Technology Solutions
•
North America
Tel: 800.366.2266 •
Europe
Tel: +353.21.244.6400
is considering for development. Performance is based on target specifications, simulated results,
•
India
Tel: +91.80.4155721
•
China
Tel: +86.21.2407.1588
and/or prototype measurements. Commitment to develop is not guaranteed.
Visit www.macomtech.com for additional data sheets and product information.
PRELIMINARY:
Data Sheets contain information regarding a product M/A-COM Technology
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available.
M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.