MAPDCC0001
Low Cost Two-Way SMT Power Divider
824-960 MHz
Electrical Specifications
1
: T
A
= +25°C
Parameter
Insertion Loss
Isolation
VSWR
Amplitude Balance
Phase Balance
Input
Output
Above 3.0dB
Rev. V4
Units
dB
dB
—
—
dB
Deg.
Min
—
15
—
—
—
—
Typ
0.5
23
1.35:1
1.25:1
0.05
0.5
Max
0.6
—
1.5:1
1.4:1
0.15
1.5
1. All specifications apply with a 50-Ohm source and load impedance.
Absolute Maximum Ratings
Parameter
Input Power
4
Operating Temperature
Storage Temperature
2.
3.
4.
2,3
Recommended PCB Configuration
Absolute Maximum
1 W CW
-40°C to +85°C
-65°C to +150°C
Exceeding any one or combination of these limits may
cause permanent damage to this device.
M/A-COM does not recommend sustained operation near
these survivability limits.
With Internal load dissipation of 0.125 W maximum.
Handling Procedures
Please observe the following precautions to avoid
damage:
Static Sensitivity
GMIC Circuits are sensitive to electrostatic
discharge (ESD) and can be damaged by static
electricity. Proper ESD control techniques should
be used when handling these devices.
2
ADVANCED:
Data Sheets contain information regarding a product M/A-COM Technology Solutions
•
North America
Tel: 800.366.2266 •
Europe
Tel: +353.21.244.6400
is considering for development. Performance is based on target specifications, simulated results,
•
India
Tel: +91.80.4155721
•
China
Tel: +86.21.2407.1588
and/or prototype measurements. Commitment to develop is not guaranteed.
Visit www.macomtech.com for additional data sheets and product information.
PRELIMINARY:
Data Sheets contain information regarding a product M/A-COM Technology
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available.
M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.