Product
Specification
Wire To Board Serial, Pitch 1.25mm
1.
SCOPE
1.1. CONTENTS
108-57273
05-JAN-2011 Rev. C
This specification covers the performance, tests and quality requirements for the
Wire To Board Serial
connector.
1.2. QUALIFICATION
When tests are performed on the subject product line, the procedures specified in AMP 109 series
specifications shall be used. All inspections shall be performed using the applicable inspection plan
and product drawing.
2.
APPLICABLE DOCUMENT
The following AMP documents form a part of this specification to the extent specified herein. Unless
otherwise specified, the latest edition of the document applies. In the event of conflict between the
requirements of this specification and the product drawing, the product drawing shall take precedence.
In the event of conflict between the requirements of this specification and the referenced documents,
this specification shall take precedence.
2.1 AMP DOCUMENTS
A.
B.
C.
D.
109-1: General Requirements for Test Specifications
109 series: Test Specification as indicated in Figure 1 (Comply with MIL-STD-202, MIL-STD-1344
and EIA RS-364)
Corporate Bulletin 401-76: Cross-reference between AMP test Specifications and Military or
Commercial Documents.
501-57299: Test Report.
3.
REQUIREMENTS
3.1. DESIGN AND CONSTRUCTION
Product shall be of the design, construction and physical dimensions specified on the applicable product
drawing.
3.2. MATERIALS
A.
Contact
Material: Copper Alloy.
Finish: Tin-Lead or Matte-Tin over Nickel plated.
B.
Housing
Material: Thermoplastic, natural color.
3.3. RATINGS
A.
B.
DR
Angus Wu
©2010 Tyco Electronics Corporation
Taipei, Taiwan
All International Rights Reserved.
* Trademark
│
Indicates change
Voltage:
100
VAC rms.
Current:
1
A for AWG#28
DATE APVD
11-NOV-2005 Wei-Jer Ke
For latest revision, visit our website at www.tycoelectronics.com\documents.
For Regional Customer Service, visit our website at www.tycoelectronics.com
DATE
11-NOV-2005
1 of 4
LOC
DW
MACOM [ Tyco Electronics ]
