28LV010
3.3V 1 Megabit (128K x 8-Bit) EEPROM
RES Signal
When RES is LOW, the EEPROM cannot be read and programmed. Therefore, data can be protected by keeping
RES low when V is switched. RES should be high during read and programming because it doesn’t provide a latch
CC
function.
Data Protection
To protect the data during operation and power on/off, the EEPROM has the internal functions described below.
1. Data Protection against Noise of Control Pins (CE, OE, WE) during Operation.
During readout or standby, noise on the control pins may act as a trigger and turn the EEPROM to programming mode by mis-
take. To prevent this phenomenon, the EEPROM has a noise cancellation function that cuts noise if its width is 20 ns or less in
programming mode. Be careful not to allow noise of a width of more than 20 ns on the control pins.
2. Data Protection at VCC on/off
03.14.03 REV 6
All data sheets are subject to change without notice 14
©2001 Maxwell Technologies
All rights reserved.
MAXWELL [ MAXWELL TECHNOLOGIES ]
